Outbound Calls getting CANCELed, Incoming calls giving Not Accepatable Media
Good day everyone,
I have just set up a SIP trunk with an ISP and I'm getting errors when I make outbound and inbound calls. For outbound calls, I get the 480 - Temporarily Unavailable message and I see a CANCEL somewhere in the debugs. For inbound calls, I see a 'Not acceptable Media' message even though i have all the codecs configured under the dial peer. My ITSP is also saying they have all the codec options available.
I kindly seek help from the community.
See confgs below:
dial-peer voice 8 voip description *** Inbound Call from SIP Server*** session protocol sipv2 session target ipv4:188.8.131.52 incoming called-number . voice-class codec 50 no voice-class sip early-offer forced dtmf-relay rtp-nte sip-kpml no vad
dial-peer voice 9 voip description ***Outgoing Call from SIP SERVER**** destination-pattern .T session protocol sipv2 session target ipv4:184.108.40.206 session transport udp voice-class sip early-offer forced voice-class sip bind control source-interface Vlan100 voice-class sip bind media source-interface Vlan100 dtmf-relay rtp-nte sip-kpml codec g711ulaw no vad
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...