Outbound FXO calls based on Signal detection

[mrmhar1408]

Hi Team,

FXO and outbound calls while the line not connected to the FXO port, is there a way to do signal detection so the call will jump to the next fxo port

[Terry Cheema]

For outbound call hunting you can use Trunk groups. You can assign multiple fxo ports to the trunk group and assign them priorty etc. From your dial-peer reference the trunk group and it will hunt the available line.

Refer to: http://www.cisco.com/en/US/docs/ios/12_3/vvf_r/vrg_t1_ps1839_TSD_Products_Command_Reference_Chapter.html#wp1491022

Also Refer: https://supportforums.cisco.com/discussion/12056631/need-sample-cme-multiple-fxo-ports-hunt-fashion

-Terry

Please rate all helpful posts and mark thread as answered if you have no other queries.