I have a UC560 with 12 FXO lines. How can I route outgoing calls based on the source.
- extension 100 to 105 should always go via FXO port 1
- extension 106 to 110 should always go via FXO port 2
You will need to configure Class Of Restriction
I have had a search for configuring CoR via CCA but I can not find very much
I dont use CCA in my day job so if it was me I would need
to use cli.
I am including another link which gives a good explanation of CoR.
You could also try asking your CCA question under the "small business forum" where I am sure
you will obtain further help.
Please rate useful posts