Outgoing call to mobile number using wrong dialpeer

[John Cheetley]

Hi Guys and Gals,

Doing a test call via Cisco phone for outgoing to a mobile number but is using the wrong dial peer.

Hoping someone can help further

Using command "sh voice call status" below while call is progressing and gives below output

See attachment for output of above command

I want the call to route via tag 2 or 3 via voip but appears to be using the default efxs 50/0/1 instead as the sh voice port summary indicates

Perhaps I have to change the default "thinking" setup?

Thanks in advance

[Aaron Harrison]

Hi

50/0/1 is a virtual voice port that represents an ephone - i.e. it's the inbound leg from IP phone to router.

You can see which DP is being used when dialling out by doing 'debug voip dialpeer default'.

Aaron