07-18-2011 12:55 PM - edited 03-16-2019 06:00 AM
Hi
I have CCM ver 7 with H323 voice gateway with 16 analog lines (FXO lines) and IPCC server , so that each analog line connected to greeting pilot number by PLAR for a certain company . as mension as below :
port 0/0/0
connection plar 1500 ----> geeting extension no for company A
port 0/0/1
connection plar 1600 ----> geeting extension no for company B
port 0/1/0
connection plar 1700 ----> geeting extension no for company C
port 0/2/0
connection plar 1800 ----> geeting extension no for company D
my question is
regarding outgoing calls , if the users or phones in company D make calls , i need to go through port 0/2/0 and not other ports
and in company A go through port 0/0/0 directly and not other ports , is there specfic configuration i have to add in voice gateway to make this scenaio well????
thanks and regards
07-19-2011 01:17 AM
please any reply
thanks and regards
07-22-2011 03:46 PM
Hi,
You could try using a different PSTN access code
for each company
91 for Comp A
92 for comp B
93 for Comp C
94 for comp D
Then write a dial peer for each
!
dial-peer voice 91 pots
desc ### PSTN ACCESS FOR COMP A ###
destination-pattern 91T
incoming called-number .
direct-inward-dial
port 1/0/0
!
!
dial-peer voice 92 pots
desc ### PSTN ACCESS FOR COMP B ###
destination-pattern 92T
incoming called-number .
direct-inward-dial
port 1/0/1
!
!
dial-peer voice 93 pots
desc ### PSTN ACCESS FOR COMP C ###
destination-pattern 93T
incoming called-number .
direct-inward-dial
port 1/1/0
!
!
dial-peer voice 94 pots
desc ### PSTN ACCESS FOR COMP D ###
destination-pattern 94T
incoming called-number .
direct-inward-dial
port 1/1/1
!
You would also have to amend you dial patterns
in Call Manager to suit.
Hope this helps
Regards
Alex
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide