cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1289
Views
5
Helpful
4
Replies

Outgoing Mobile calls not working on PSTN LINE

Greetings,

 

I have cisco VG configured as H323 With 1 PSTN LINE on FXO port. 

I have Call Manager 11.5.

 

On call Manager i configured gateway as H323. Created Route patterns with Gateway.

9.05[0-4]XXXXXXX  for 10 digit mobile

9.[2-4]XXXXXX for 7 digit local call

9.0[23679]XXXXXXX for 9 digit national call

9.8XXXXXX for 7 digit services number

9.9XX for emergency number

 

On gateway I have following pots dial-peer for outgoing calls.

 

dial-peer voice 101 pots

destination-pattern 9T

port 0/1/0

 

and VOIP dial-peer for incoming calls pointing to CUCM.

 

Now local, emergency, services calls are working fine. But when making a mobile or national call, it rings on the mobile once and gives message " Your call cannot be completed as dial, please confirm your directory and call again..... "

 

I have attached the debug for outgoing calls. 

Kindly advice.

 

2 Accepted Solutions

Accepted Solutions

Ammar Saood
Spotlight
Spotlight

You may want to start with verifying that the CSS on the phone has the access to the partition of route pattern mobile or national call.

 

suppose your Phone CSS is CSS-phone.

 

Route pattern 9.05[0-4]XXXXXXX is in partition pt-Mobile

Route pattern 9.0[23679]XXXXXXX is in partition pt-National

 

Make sure CSS-Phone has access to the above pt-Mobile and pt-National patterns.

Also make sure you are sending the correct calling number to your provider. You can also use  "Calling Party Transform Mask" setting on these route pattern and put main DID number provided by PSTN provider.

 

Hope this helps.

If this was useful, please mark it "helpful" or "accept as solution".

View solution in original post

Thank you for your reply,

 

Finally I managed to solve the issue it was with FXO port.

Earlier I was using few parameters, i removed all and all In out calls are working fine.

 

 

View solution in original post

4 Replies 4

Ammar Saood
Spotlight
Spotlight

You may want to start with verifying that the CSS on the phone has the access to the partition of route pattern mobile or national call.

 

suppose your Phone CSS is CSS-phone.

 

Route pattern 9.05[0-4]XXXXXXX is in partition pt-Mobile

Route pattern 9.0[23679]XXXXXXX is in partition pt-National

 

Make sure CSS-Phone has access to the above pt-Mobile and pt-National patterns.

Also make sure you are sending the correct calling number to your provider. You can also use  "Calling Party Transform Mask" setting on these route pattern and put main DID number provided by PSTN provider.

 

Hope this helps.

If this was useful, please mark it "helpful" or "accept as solution".

Thank you for your reply,

 

Finally I managed to solve the issue it was with FXO port.

Earlier I was using few parameters, i removed all and all In out calls are working fine.

 

 

When dialling 10 digit mobile number, VG is  using dial-peer "Outgoing Dial-peer=102". And when dialling 7 digit number its using 101 dial-peer. 

 

Whats your 102 dial-peer?

 

Since its an analogue line ,  Calling number has no role and external phone number mask doesn't make any impact on  the call.  

 

 



Response Signature


Appreciate your reply.