cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
569
Views
0
Helpful
1
Replies

Overhead Paging Cooper SP40s System - Connecting to FXO or FXS?

j.shrewsbury
Level 1
Level 1

We have a site that just installed a Copper Industries SP40s paging system. (See link below)

http://www.cooperindustries.com/content/dam/public/safety/notification/Resources/Instruction%20Sheets/P84714.pdf

The information provided by the vendor is:

we need an "sa phaseport 600 ohm 1 volt peak to peak and if that is not available then we need a module to convert signal to line level"

I have a 2921 with FXO card as well as a VG204. I am trying to determine if either of these will work, or if I need an intermediary device. 

Any suggestion on how to configure this would be greatly appreciated. 

 

1 Reply 1

j.shrewsbury
Level 1
Level 1

Anyone?