Overhead paging system

[kraghavansag]

Hi,

I am trying to integrate legacy overhead paging system with Cisco. I have a VG248 GW with FXS ports and 2800 series router with FXO ports available. There is also a Bogen's TAMB installed. the last time I tried interfacing with the paging syetm using TAMB on FXS, it did not work. Any ideas on where to start troubleshooting?

[tmsheikh]

I have configured both ends i.e Boegn TAMB with loopstart and fxo port 2811, configured the cucm to pass the digits.

However, There is a delay when I dial the DN and secondly, I hear the DTMF tones before the actual announcement on the overhead paging. Any ideas why that is?