password recovery VG320

[monasir]

Hi everyone,

I've configured a basic configuration for the VG320 analog gateway, ive copied pasted the running config in the gw.

I'm not able to login anymore because i cannot retrieve the password.

Is there a possibility to do a password recovery?

[Manish Gogna · Accepted solution]

Plz check this, it applies to VG3XX as well

http://www.cisco.com/c/en/us/support/docs/routers/2600-series-multiservice-platforms/22188-pswdrec-2600.html

Manish

[Nadeem Ahmed · Accepted solution]

Hello,

Edit: Connect console cable directly with laptop and VG350 then perform below steps for recovery of password

1) Power off the router

2) Turn it back on

3) Break into rommon

4) Enter "confreg 0x2142"

5) Enter "reset"

6) An empty router will come up

7) Enter "copy startup-config running-config"

8) This will load the usual configuration of the router into  NVRAM

9) Change the passwords as required.

10) Enter "conf t" then in global config enter "config-register 0x2102"

11) Write to memory

11) Reload router and test password.

Br,
Nadeem Ahmed