cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
196
Views
0
Helpful
0
Replies
Highlighted
Beginner

Peer Firmware Sharing or Load Server in CM 5.1(3)

Someone have used some of these feature?

I'm planning an CM upgrade in a customer with 4,000 phones distributed over 140 sites and many of them have low speed links (< 512 kbps). So my ideas are:

I) Enable Peer Firmware Sharing, but I don't know if this work in CM 5.1(3), I think that this setting must be enabled before CM upgrade.

II) Load the new firmware (mainly for SIP firmwares) in gateways flash memory, and use them as 'Load Server'. But again, I think that I must enable this feature before CM upgrade.

Best Regards,

Fabio Funaki

0 REPLIES 0
Content for Community-Ad