Hi Team,
I have configured PLAR in VG224 Analog port which connected to Intercom ( Analog Door Bazzar). This Analog port configured as SCCP port which registered with CME 8.0.
Now issue is:
1. Some one push the intercom button, it start ringing on IP Phone. IP Phone user pick up the call and ask the visitor to come in. When the IP Phone user On Hook, the Phone start ringing again.
I have configured the supervisory Disconnect in VG224 but still same issue. Here the configuration:
!
dial-peer voice 919 pots
no tone dialtone remote-onhook
tone busytone remote-onhook
service stcapp
port 2/19
!
!
voice-port 2/19
timeouts ringing infinity
timeouts power-denial 10
caller-id enable
!
My Finding that If I Press 2 to 3 times on hook button on the IP phone then Intercom getting busy signal but it is coming on-hook after 3 minis.
Please let me know how to make the PLAR port on-hook once IP phone disconnected the call.
Your quick response will be highly appreciated.
Regards,
Nirmal