PLAR sendind calling number

[c.rodriguezesteban]

Hello, im quite new to voip world, so i have a rewarding and challenging

Job, there is my question.

I manage a little network, we have a few PSTN lines to our GW, some of these lines are "fowarded" to IP extensions within the network using PLAR but i cant get the caller number to be displayed in the ip phone

Any suggestions?

Thanks in advance

Cesar

[gogasca]

Hola Cesar,

First question is if you connect an analog phone do you recieve Caller ID from Telco?

Then enable caller id in voice ports by using caller-id enable command

http://www.cisco.com/en/US/docs/ios/12_3t/voice/command/reference/vrht_c4.html#wp1059594

Then you can post your config and run some debugs:

debug voice ccapi ino

debug vpm signal