Is there a Cisco access switch feature to disable a switchport if a device is attached directly to the port and it is not a Cisco phone?
Go to Solution.
Configuring Auto Smarports and Static Smartports Macros
View solution in original post
How? Can you give an example?
Here's a good explanation about AutoSmartPort:
Configuring Auto Smartports Macros
you want to disbale from POE power that it is giivng when plug up ip phone
if you are plugging nay non ip phone device, for saving part use the commands:
under switch interface:
#int fa 0
# no poe power
please check the commands for this aprt under interface.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: