Hello
I was setting up CUBE with SIP Trunk to the PSTN. This router is also set up for SCCP SRST, we have some dial-peer pots configured.
After configuring this dial-peers we saw messages trying to register.
To stop this we configure the command "no sip-register"
dial-peer voice 7000 pots
destination-pattern ........
port 0/2/0
no sip-register
!
But I can't find, how to stop register message in a e-phone dial-peer pots when this router is in SRST mode ?
CUBE_GOLD#show sip-ua register status
Line peer expires(sec) registered P-Associ-URI
================================ ========== ============ ========== ============
67952 20001 95 no <--------------------------------!!!!!!!!
8182862940 -1 49 yes
CUBE_GOLD#
CUBE_GOLD#sh dial-peer voice sum
dial-peer hunt 0
AD PRE PASS OUT
TAG TYPE MIN OPER PREFIX DEST-PATTERN FER THRU SESS-TARGET STAT PORT KEEPALIVE
5001 voip up up 0 syst sip-server
5002 voip up up *320T 0 syst sip-server
5003 voip up up 0 syst sip-server
5004 voip up up 294. 0 syst ipv4:172.31.1.254
20001 pots up up 67952$ 1 50/0/1 <--------------------------------!!!!!!!!
20002 pots up down 1 50/0/2
call-manager-fallback
max-conferences 8 gain -6
transfer-system full-consult
ip source-address 172.31.3.1 port 2000
max-ephones 10
max-dn 20 dual-line preference 1
system message primary MODO SUPERVIVENCIA
system message secondary MODO SUPERVIVENCIA
keepalive 20
!
