cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
330
Views
5
Helpful
1
Replies

PRI Failover

dpuranik
Level 1
Level 1

I have 2 MGCP gateways and each have 1 PRI. These PRIs are under same Route Group. If my primary PRI fails then calls are not routed off of 2nd PRI, but calls routed off of next Route Group which is my backup location.

Following Service Parameters are set to "False"

Stop Routing on Out of Bandwidth Flag Required Field         
Stop Routing on Unallocated Number Flag Required Field         
Stop Routing on User Busy Flag Required Field

Is this the default behavior of Route Group or am I missing any configuration?

 

Thanks,

1 Reply 1

Ayodeji Okanlawon
VIP Alumni
VIP Alumni

No, this is not normal. I will suggest you start by looking at what the gateway is sending to cucm. The gateway should be sending a user busy flag...

debug isdn q931

Once we establish that we can then move on to looking at cucm traces and see why cucm is not picking the next endpoint..

Please rate all useful posts