07-10-2009 12:14 PM - edited 03-15-2019 06:55 PM
HI,
We have a 2801 GW running IOS c2801-spservicesk9-mz.124-11.XW10.bin. GW has a PRI. Call manager version is 4.1.3 sr5d
Outbound calls work fine however we cannot get any inbound calls to complete.
Attached is a debug isdn q931 and debug voice ccapi inout and a config of the router.
From the debug voice ccapi inout the call hits dial-peer 100 and then bounces to dial-peer 101. Does this indicate an issue with Call Manager? We've configured our H323 gateway in CCM as we normally do.
Thanks
Quinn
07-13-2009 07:41 PM
ccapi isn't going to give you the details you need for this.
debug h225 asn1
debug h245 asn1
debug ip tcp transactions
These will allow you to see if cucm is communicating back to the gateway. My guess is that it is, because normally if there is no response you'll see cause=38 for network out of order or cause=47 resources unavailable.
Sounds like an h323 issue possibly on CUCM. Hard to tell.
-nick
07-18-2009 11:53 AM
07-18-2009 11:48 AM
Modiying the POTS dial-peer to:
dial-peer voice 1 pots
voice cut-through alert
tone ringback alert-no-PI
preference 1
incoming called-number .T
destination-pattern 1T
progress_ind alert enable 8
direct-inward-dial
port 0/1/0:15
had no effect.
thanks
07-19-2009 05:59 PM
not sure if this may help but id normally not apply the translations to the Voice port itself and apply to the dial-peer instead.
Id say remove the profiles on the Voice port and put the incoming called number as the PSTN pilot number or pattern coming in into your dial peer and then apply the tanslation profile incoming to match the rule that you need the call to be terminated against.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: