Prime Line not working for "New Call" softkey on secondary and tertiary lines
Currently have a Call Manager: 184.108.40.20600-14 with 8851 phones running the latest firmware 12-1-1SR1-4. We currently have Prime Line on globally and it is working as intended. However, when we highlight the second or third line and off hook via "New Call" softkey, the prime line future is broken and it makes the call out of the second line instead of the primary line.
Was able to find a solution to this. On the phone screen in Call Manager under Product Specific Configuration Layout > Line Mode> Switch to "Enhance Line Mode". This will ensure that second/tertiary lines and so forth will switch back to the primary line after use. It does disable the "New Call" softkey on those secondary lines.
“UCCE Solution Troubleshooting Based on Comprehensive Call Flow for CVP and IP IVR Deployment Models”
This event will have place on Thursday 22, October 2020 at 10hrs PDT
Contact Center call flows are fundamental to the successful implementation an...
[ The link to the discussion will be published on October 22nd ]
This topic is a chance to clarify your questions about the implementation, best practices and support of Customer Voice Portal (CVP) and IP Interactive Voice Response (IP IVR) deploymen...
I have questions from the above guides:
A company currently has two different UC environments. One in the US and one in the UK. The US UC environment has (3) CUCM servers (Publisher and 2 subscribers), (2) IMP servers (P...
IP telephony (Internet Protocol telephony) is a term used to describe technologies that use a variety of protocols to exchange voice, fax, and other forms of information, traditionally carried over the Public Switched Telephone Netwo...