cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
547
Views
0
Helpful
4
Replies

Problem in voice-port of pstn gateway

n4niteshkumar
Level 1
Level 1

Hi folks,

I have installed Cisco 3845 router as PSTN gateway and terminated POTS line on voice-port 0/2/2 of HWIC module. Required configuration for voice-port and dial-peer is done as per standard. But I am unable to place/receive calls on pots line through PSTN. No output is shown for "show voice call status". While doing "debug vpm signal" the following message is displayed

htsp_process_event : [0/2/2,S_DOWN,E_DSP_SIG0000]

htsp_process_event : [0/2/2,S_DOWN,E_DSP_SIG0100]

 

Does it mean unserviceable of HWIC card or voice-port?

4 Replies 4

show full debug. Also, do you have DSP module installed and compatible with
3845


****** remember to rate useful posts

Thanks for your response. DSP module is installed in PSTN but don't know whether it is compatible with 3845.

Only the "debug vpm signal" is being displayed and no output for other debug like debug ccapi voice input.

Can u specify what other debug logs is required and which DSP module is compatible with 3845?

n4niteshkumar,

show voice dsp

This will give you some useful information.

 

 

"look for PVDM. If they are installed and working they will show up here. If they aren't working you will not see anything".

Command: show inventory

NAME: "PVDMII DSP SIMM with four DSPs on Slot 0 SubSlot 4", DESCR: "PVDMII DSP SIMM with four DSPs"
PID: PVDM2-64          , VID: V01 , SN: FOC13132AQ1
NAME: "PVDMII DSP SIMM with three DSPs on Slot 0 SubSlot 5", DESCR: "PVDMII DSP SIMM with three DSPs"
PID: PVDM2-48  


@Mohammed al Baqari wrote:
show full debug. Also, do you have DSP module installed and compatible with
3845


****** remember to rate useful posts


@Mohammed al Baqari wrote:
show full debug. Also, do you have DSP module installed and compatible with
3845


****** remember to rate useful posts



Thanks for your response. DSP module is installed in PSTN but don't know whether it is compatible with 3845.

Only the "debug vpm signal" is being displayed and no output for other debug like debug ccapi voice input.

Can u specify what other debug logs is required and which DSP module is compatible with 3845?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: