Hi,
I have one Cisco 2911 configured as Internet Router and CME.
Some IP telephones working in SCCP mode working greate, and two analog phones.
I can't sucessfull transfer calls that analog phones receives to IP Phones.
Soon as I receive the call in analog phone, when I press FLASH button:
I got the tone to dial
I can sucessfull dial to other internal extension (other analog or IP phone)
The internal call establishes successfully, but when I hang up or press FLASH again it just disconnect with destination phone.
The external call is no more connected to any extension at this point, but the line still connected (mute).
Config:
ROUTER#sh conf | sec stcapp
stcapp ccm-group 1
stcapp
stcapp feature access-code
prefix *#
call forward all 2
call forward cancel 9
pickup group 1
stcapp supplementary-services
port 0/2/0
hold-resume
fallback-dn 1050
port 0/2/1
hold-resume
fallback-dn 1040
stcapp call-control mode feature
transfer *#3
service stcapp
service stcapp
ROUTER#sh stcapp device summary
Total Devices: 2
Total Calls in Progress: 1
Total Call Legs in Use: 0
Port Device Device Call Dev Directory Dev
Identifier Name State State Type Number Cntl
---------- --------------- -------- ------------- ------- ----------- ----
0/2/0 ANE4AA7533D0100 IS IDLE ALG 1050 CME
0/2/1 ANE4AA7533D0101 IS IDLE ALG 1040 CME