cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
96
Views
0
Helpful
3
Replies
Highlighted

PSU Redundancy in CUCM 8.6 vs 8.5

I have two servers. one is running 8.6 and another is running 8.5

on 8.5 i can see PSU redundancy using command:

admin:show environment power-supply

Power supply #1
Present : Yes
Redundant: Yes
Condition: Ok
Hotplug : Supported

Power supply #2
Present : Yes
Redundant: Yes
Condition: Ok
Hotplug : Supported

How can i see the same current REDUNDANCY Level of PSU on CUCM 8.6?

There are old MCS series servers

Everyone's tags (4)
3 REPLIES 3
Advisor

Hi,

Hi,

what happens when u run same commands on CUCM 8.6?

regds,

aman

gives me only for both PSU. :

gives me only for both PSU. :( no info on redundancy..

status: ok

Advisor

Hi,

Hi,

I believe the output of command depends on MCS model whether it is IBM or HP.

I checked on IBM , it shows power-supply OK while HP shows Redundant : Yes and Hotplug: Supported.

I also checked the CLI guide and have attached the snapshot.

regds,

aman

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards