cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
422
Views
0
Helpful
3
Replies

PSU Redundancy in CUCM 8.6 vs 8.5

I have two servers. one is running 8.6 and another is running 8.5

on 8.5 i can see PSU redundancy using command:

admin:show environment power-supply

Power supply #1
Present : Yes
Redundant: Yes
Condition: Ok
Hotplug : Supported

Power supply #2
Present : Yes
Redundant: Yes
Condition: Ok
Hotplug : Supported

How can i see the same current REDUNDANCY Level of PSU on CUCM 8.6?

There are old MCS series servers

3 Replies 3

Aman Soi
VIP Alumni
VIP Alumni

Hi,

what happens when u run same commands on CUCM 8.6?

regds,

aman

gives me only for both PSU. :( no info on redundancy..

status: ok

Hi,

I believe the output of command depends on MCS model whether it is IBM or HP.

I checked on IBM , it shows power-supply OK while HP shows Redundant : Yes and Hotplug: Supported.

I also checked the CLI guide and have attached the snapshot.

regds,

aman

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: