PVDM Share

[Young Chan Lee]

Hello
I have c3745 router
It has 2mft-e1, 2mft-t1 and two pvdm-32 on nm module
2mft-t1 on nm module, e1 on onboard wic
I try to create controller
2 t1 is alright (each 5 channel) but 2 e1 cannot create because not enough dsp.
Can I solve this problem?
Thanks
Sent from Cisco Technical Support Android App

[Ayodeji Okanlawon]

Add more dsps or reduce the number of e1 channels..

Please rate all useful posts

"opportunity is a haughty goddess who waste no time with those who are unprepared"

[susolomo]

If you do not want to buy new dsp , check if you have unnecessery media resources configured. Such as confrence bridge or xcoders. You can try removing 1 conf session and it will allow you some channels to configure.