Errors and call drops, since moving over to Windows 7 SP1 64bit from Windows XP SP3 32bit
Error: C++ R6025 - pure virtual function call
Drops: Users have two lines, an extension and an ICD extension, if a call is active on a extension when they get an ICD call and go to either hold the first caller or just answer the incoming, ICD call gets dropped. Sometimes phone just shuts down with a headset disconnected message and sometimes without a message.
Windows 7 SP1 computers
Logitech H340 (Happens with this headset or much more often with it. Oddly enough a different brand headset seems to encounter this issue 100 times less. Can cause more frequent if user, uses the answer button in a line.)
IPCommunicator 8.6.2 (8.6.3 can't log onto a phone using Extension Mobility Service. Nothing under services.)
Cisco Unified CM Administration, System version 184.108.40.20600-5
Cisco Unified CCX Administration, System version 220.127.116.1102-22
I'm hoping that someone else has already found a work around. Please help if you can.
User's damaging USB plugs and USB ports was my main issue. Causing the communicator to close and users to lose calls. I really wish USB had been made sturdier. Even in 10.5 I still occasionally here about the R6025 error. My solution is to have users move their headset to a different USB port or replace their headsets. I have notice that Windows does not always load a valid driver for headsets and sometimes switching ports will cause it to reload the correct driver. Shutting down the communicator mid call because of a headset disconnect is a poor programming design. Perhaps a pop up that say your headset has been disconnected? Allow the user to transfer the call back to the operator? Obviously Cisco feels that dropping calls is ok.
As for version 8.6.3 and up not showing my extension mobility service. It only shows services that have a Secure-Service URL. Mine at the time only had Service URLs. Not sure why the switch, but I had played around with a test service until I realized what was happening. Prior phones would show two services if both URLs were populated.
Hi,I'm facing problem while trying to login Cisco Prime License Manager. When I type login and password it show me “Invalid Username or Password. Please try again.”. But login and password correct. I reset password but it is show the same error. &nbs...
Hello everyone,after updating the CUCM to the last version 18.104.22.16800-97 a customer complains about errors on an applications server. These errors did not occur before the update. Phones can no longer be controlled. Only after a reinitialization of the ...
Hello, We have been facing issues with backup of drfcomponent.XML & Processnode.XML files to our backup servers during scheduled Backup in our CUCM 11.0 servers.We have been using Titan FTP server for Backup. I see error on backup statusERRO...
To participate in this event, please use the button to ask your questions
At the beginning of 2020, no one would have imagined the changes in work and learning habits that we would face in the foll...