cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

260
Views
5
Helpful
4
Replies
Highlighted
Beginner

Region / Location BW issue Video Endpoints

Hello All, 

 

I have 6 Video Units: 

Cisco TelePresence Profile 52 Dual (C60)

Cisco TelePresence SX20

Cisco TelePresence SX20

Cisco TelePresence SX20

Cisco TelePresence SX10

Cisco Spark Room 55

 

All are in the same region also in the same location,  as per customer advise they need to set 2M BW for each unit and also have a limitation on the location BW to be up to 14M which is (2*M*6Units) +2M reserve =14M 

Location Immserve BW (14M)

Location Video BW (14) 

When we do the previous scenario only 3 Endpoints work V/A and the other 3 work Voice only 

 

but when we set the Location BW 

Location Immserve BW (unlimited)

Location Video BW (unlimited) 

Everythings work fine 

 

Region: Factory Default low loss 256 kbps (L16, AAC-LD) 32000 kbps 2147483647 kbps

 

Default Intraregion Max Video Call Bit Rate (Includes Audio) Required Field (384)

Default Intraregion Max Immersive Video Call Bit Rate (Includes Audio) Required Field ( 2M) 

 

I need to know what is the right setting so they all can work fine with limited BW 

 

 

 

 

 

 

 

 

 

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Beginner

Re: Region / Location BW issue Video Endpoints

Hello Anthony, 

 

Appreciate your help. 

 

Use Video BandwidthPool for Immersive Video Calls set to (True) 

 

View solution in original post

4 REPLIES 4
Highlighted
VIP Collaborator

Re: Region / Location BW issue Video Endpoints

Hi,

Please try below settings:

Under Region Section:

Maximum Session Bit Rate for Video Calls: 2000 kbps

Maximum Session Bit Rate for Immersive Video Calls: 2000 kbps

Under Locations Section:

Capture.JPG

Remember to set MaxTransmitCallRate and DefaultCall Rate on each video endpoint to 2000. For this, you need to login to each video endpoint.

 

Please rate helpful posts and if applicable mark "Accept as a Solution".
Thanks, Vaijanath S.
Highlighted
Beginner

Re: Region / Location BW issue Video Endpoints

Hello Vaijanath,

That's the case when I do the above configuration you advised me with the issue happens

Thanks for your help.
Highlighted
VIP Mentor

Re: Region / Location BW issue Video Endpoints

What is your CallManager Service Parameter for Use Video BandwidthPool for Immersive Video Calls set to?

Anthony Holloway
Highlighted
Beginner

Re: Region / Location BW issue Video Endpoints

Hello Anthony, 

 

Appreciate your help. 

 

Use Video BandwidthPool for Immersive Video Calls set to (True) 

 

View solution in original post

CreatePlease to create content
Content for Community-Ad

Cisco COVID-19 Survey