cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
853
Views
8
Helpful
5
Replies
Eugen Bitca
Beginner

register csico phone

Hello,

Howo to have dual line Cisco Phone to be registered each line per different server?

 

Thanks.

5 REPLIES 5
Chris Deren
Hall of Fame Master

Each device registers to single server at a time with all extensions, not sure why you would want each line registered to different servers. Can you elaborate?

Chris

I have attached ip call scenario.

Jaime Valencia
Hall of Fame Cisco Employee

Choose to which cluster you will register the phone, and both lines, and then emulate that behavior via call routing (CSS/partitions/RPs) 

HTH

java

if this helps, please rate
mohamed helmy
Beginner

Hello Eugen,

 

Is this the same cluster?

if you want Line two to go through PSTN2, simply use CSS points to RL of PSTN2

 

Regards,

Mohamed Helmy.

Regards, Mohamed Helmy
manpreetsingh46
Beginner

Hi Eugen,

 

You can not register the lines of the phone . Phone registers to the server. If you need the lines of the phone to use different gateway than you can use partiton/CSS . you need to create an ICT or SIP trunk between your two clusters and than create a route pattern, such that it will send the call through the ICT and than other server can route it through its gateway.

 

 

NOTE: for this kind of setup you would be using your WAN bandwidth so configure it to use G729

Create
Recognize Your Peers
Content for Community-Ad