03-27-2014 02:43 AM - edited 03-16-2019 10:16 PM
Hello,
Howo to have dual line Cisco Phone to be registered each line per different server?
Thanks.
03-27-2014 06:39 AM
Each device registers to single server at a time with all extensions, not sure why you would want each line registered to different servers. Can you elaborate?
Chris
03-29-2014 07:34 AM
03-30-2014 09:29 PM
Choose to which cluster you will register the phone, and both lines, and then emulate that behavior via call routing (CSS/partitions/RPs)
03-30-2014 02:49 AM
Hello Eugen,
Is this the same cluster?
if you want Line two to go through PSTN2, simply use CSS points to RL of PSTN2
Regards,
Mohamed Helmy.
03-31-2014 01:36 AM
Hi Eugen,
You can not register the lines of the phone . Phone registers to the server. If you need the lines of the phone to use different gateway than you can use partiton/CSS . you need to create an ICT or SIP trunk between your two clusters and than create a route pattern, such that it will send the call through the ICT and than other server can route it through its gateway.
NOTE: for this kind of setup you would be using your WAN bandwidth so configure it to use G729
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: