03-10-2014 12:30 PM - edited 03-16-2019 10:04 PM
Trying to figure out if it is possibe to release an extension for use again for auto-assign once a phone is unplugged. I test phones, mainly 79xx series, and it gets old fast having to do no ephone 1 2 3 ... when all of the extensions have been handed out.
03-10-2014 11:22 PM
Hi Zach,
I don't think such a functionality is feasible, as this would result is wiping out configuration even in case of following scenarios:
> ethernet cable gone bad
> someone accidentally unplugging the phone
> if the port to which the ip phone is connected is shut administratively or if it goes bad
HTH
Manish
03-11-2014 01:47 AM
Ah, understandable. Thanks anyway.
03-11-2014 07:01 AM
You could probably write an EEM or TCL script to remove the ephone configuration once the ephone unregistration log message is printed.
03-11-2014 09:28 AM
Never thought of that. Thanks for the idea.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: