cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
571
Views
0
Helpful
2
Replies

RightFax config for 2911 router and Call Mgr

Yort Mantup
Enthusiast
Enthusiast

Hello,

I am trying to configure a POTS line running to an FXO port on a 2911 router.  Currently when i test I get connection (no tones) then the call drops.  My path is PSTN --> FXO --> CM (mgcp) -- RightFax.  I have a route pattern for the number pointing to a trunk configured for connection to RightFax.

Router - 2911 running 15.0(1)MS

Call Manager 8.5

I have enabled T.38 and the appropriate commands and dial peers.  At least to my knowledge.  I attached the mgcp, voiceport and dial-peer config below.  Looking for some advice as to what I may be missing. 

2 Replies 2

Sven Ravenstein
Beginner
Beginner

Hello,

you are calling from external into your mgcp gateway to the faxserver?

Is the Faxserver connected to fxo port 0/2/1 ?

The gateway is properly registered?

Regards,

Sven

Yes that is correct.  I found the issue late yesterday.  My device pool in Call Manager was not configured correctly.  I now have this working. 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: