cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
449
Views
0
Helpful
1
Replies

Route Pattern with time based

ievalleyccie
Beginner
Beginner

Is there a method to configure RP (Route pattern ) to block any  calls outside working hours ?

I am using CUCM 8.6

1 Accepted Solution

Accepted Solutions

Yes sure you can use RP to block calls based on time of the day. You will need to use Time of day routing to do this..

The link above shows how to configure time of day routing..

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080a7bc96.shtml

Once you have created your time periods and schedule, assign time schedules to partition and assign partition to RP.

You then create two RP as follows

RP1, in pt-OOH

under route option, you selct block this pattern

RP2, in pt-OH

select route pattern

Please rate useful posts

Please rate all useful posts

View solution in original post

1 Reply 1

Yes sure you can use RP to block calls based on time of the day. You will need to use Time of day routing to do this..

The link above shows how to configure time of day routing..

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080a7bc96.shtml

Once you have created your time periods and schedule, assign time schedules to partition and assign partition to RP.

You then create two RP as follows

RP1, in pt-OOH

under route option, you selct block this pattern

RP2, in pt-OH

select route pattern

Please rate useful posts

Please rate all useful posts
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers