cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1149
Views
0
Helpful
1
Replies

SAF Voice service - Simple deployment

santiago
Level 1
Level 1

Hi all,

I've spent long days trying to understand the most basically deploment  of the SAF voice service.

(i've guided myself via the next links http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/feature/guide/SAF_FeatureModule.html#wp1194872 and

http://docwiki.cisco.com/wiki/Service_Advertisement_Framework_Support_in_Unified_Communications_-_System_Test_Configuration  )

My lab deploment consists on 2 CME's:

CME A:

dn range 2000-2500

PSTN connection via PRI E1.

CME B:

dn range 3000-3500

No PSTN connection

All i need from an early beggining is to share ( advertise ) the dial-peer of CME A to CME B. Then CME B will be able to dial PSTN numbers.

Also, the hosted-dn ( dn ranges ) to call between them ( CME A and B ) only by advertising their DNs.

From my understandings, i did configured a SAF forwarder, but the adverstising was no successfull.

Any advice will wellcomed.

Thanks,

1 Reply 1

Ben Rodriguez
Level 1
Level 1

I know this is really old but you can simply use dial peers from CME to CME with the remote range from A to B and vice versa. Unless you are setting this up for learning purposes I say keep it simple if it is only two sites.