HI there, we have following route pattern for Auckland NZ, 1 is access code:
those are just for the office in Auckland to ring local number, I blieve there must be some simplier one for Auckland, like what we have here in sydney 0.02  XXX XXXX or 0.XXX XXXX for local. I am looking at the WiKipedia, but I would apreciate if you can share with me your route pattern for Aucklan office in your CUCM?
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...