05-11-2015 11:20 AM - edited 03-17-2019 02:57 AM
Hello!
I use a script its-CISCO.2.0.3.0.tcl for AA services in CME 10.5. Script config:
!
application
service aa flash:its-CISCO.2.0.3.0.tcl
paramspace english index 0
paramspace english language en
param operator 21
paramspace english location flash:
paramspace english prefix en
param aa-pilot 4999
!
dial-peer voice 4999 voip
service aa
destination-pattern 4999
session target ipv4:172.16.1.1
incoming called-number 4999
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
!
voice-port 0/2/0
connection plar opx 4999
impedance complex1
caller-id enable
!
Script works, but I do not see caller-id on destination phone. I see on phone caller-id 4999. Also when an external line attempts to connect through the system, but the external POTS phone disconnects before the IP phone user picks up – the IP phone will ring FOREVER – until the IP phone is taken off-hook.
What can cause the problem?
Regards,
Kamil
05-11-2015 11:46 AM
When I remove "dial-peer voice 4999 voip" and set:
dial-peer voice 301 pots
service aa
incoming called-number .%
direct-inward-dial
port 0/2/0
I have "Unknown number".
Whats wrong?
Regards,
Kamil
06-15-2016 04:54 AM
SOLVED??!!
11-13-2017 02:46 AM
Hi
What did you done that solved that.
Thanks
12-10-2016 03:28 PM
Hello,
Do you know if this script works in SRST mode with sccp and sip ip phones?
Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: