12-22-2006 09:51 AM - edited 03-14-2019 07:19 PM
I cannot seem to figure out why I keep getting a secondary dial tone when I dial from extenstion 1000 to extension 2000. If I dial 2000 from my extension 1000 phone I get a second dial tone then if I dial 2000 again the call goes through. If I do the opposite from 1000 to 2000 it works just fine. I can direct dial 1000 from 2000. Any help would be great. I have attached a drawing with the dial peers. Any Ideas?
12-22-2006 10:17 AM
Justin,
Your inbound calls are not matching the POTS peers that have the direct inward dial defined, and are matching the default peer 0.
You can use a show call active voice brief to prove this.
The fix is to add this command to your POTs peers:
incoming called-number ....
Please rate helpful posts.
Dave
12-22-2006 10:34 AM
Dave they were matching as when I did show dial-peer voice summ. they were there. They were ephones. I think this is just some kind of buggy code. all I did is delete them and readd them, out of a desperate attempt to get this working, and that appeard to fix the problem. Thanks for taking a peak.
12-22-2006 10:32 AM
Ok, I got it working. I just deleted and readded the ephones. I am not sure what the problem was but that appeared to fix it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide