cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
492
Views
0
Helpful
2
Replies

Secure RTP em Gateways SIP

Pessoal,

Preciso habilitar criptografia (Somente SRTP) em Gateways utilizando o IOS c3900-universalk9-mz.SPA.151-4.M2.bin, com uck9.

Habilitei somente o comando a seguir. (Observação: Não identifiquei nenhum outro comando para Secure RTP.)

voice service voip

ip address trusted list

ipv4 0.0.0.0 0.0.0.0

allow-connections h323 to h323

allow-connections h323 to sip

allow-connections sip to h323

allow-connections sip to sip

fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback cisco

sip

bind control source-interface Loopback0

bind media source-interface Loopback0

session transport tcp

srtp negotiate cisco

!

Utilizo sinalização SIP em todos os Gateways. E tenho as dúvidas a seguir:

- Estou configurando corretamente?

- Qual o comando mais apropriado para verificar o SRTP?

- Verifiquei a saída do comando show call active voice e o parâmetro SRTP está igual a off.

Desde já agradeço.

--

Luciane de Medeiros

2 Replies 2

paolo bevilacqua
Hall of Fame
Hall of Fame

Unless you post in English, your chances of getting a good answer, are very diminished.

Hi Paolo,

I need to enable encryption (SRTP Only) in Gateways using IOS c3900-universalk9-mz.SPA.151-4.M2.bin with uck9.

I enabled only the following command. (Note: I have not identified any other commands for Secure RTP.)

voice service voip
  ip address trusted list
   ipv4 0.0.0.0 0.0.0.0
  allow-connections h323 to h323
  allow-connections h323 to sip
  allow-connections sip to h323
  allow-connections sip to sip
  fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback cisco
  sip
   bind control source-interface Loopback0
   Average bind source-interface Loopback0
   session transport tcp
   srtp negotiate cisco
!

The SIP protocol is used on all Gateways. And I have the following questions:

- I configured correctly?

- What is the most appropriate command to check the SRTP?

- I checked the output of the show call active voice command and the parameter SRTP is equal off.

Thank you.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: