04-16-2012 02:16 PM - edited 03-16-2019 10:40 AM
Hi,
I have a customer with a cme 8 that needs to send the special code #00 that connects to another system in a sip trunk.
I did a dial-peer with this destinattion-pattern like this:
dial-peer voice 30 voip
description ** #00 call **
destination-pattern #00
rtp payload-type nte 99
session protocol sipv2
session target sip-server
dtmf-relay rtp-nte
codec g711ulaw
The calls always fail
I did a "debug voip dialpeer all" and i found that the CME when i call the #00 it see the called number as: T00 and the dial-peer never match
How can i do to make this work?
If i use another special charactar like *00 it works, but is necesary the #00
Regards,
Solved! Go to Solution.
04-16-2012 02:32 PM
IOS uses # as termination key, you can change that with following command:
dial-peer terminator A
HTH,
Chris
04-16-2012 02:32 PM
IOS uses # as termination key, you can change that with following command:
dial-peer terminator A
HTH,
Chris
04-16-2012 02:40 PM
Hi Chris
This solve my issue
Thanks a lot
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide