cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
868
Views
0
Helpful
2
Replies
Contributor

Send the number and name on Caller ID via ISDN Qsig

Hi, good afternoon!

I need help to set up an ISDN - QSIG

On one side is 5.1 CCM 3725 with a router connected to a PBX Avaya via ISDN Qsig

I need to connect to the environment Cisco Avaya need to know if you can send the number and name on Caller ID

below the current configuration

interface Serial1 / 0:15

No IP address

encapsulation hdlc

logging in the event link-status

isdn switch-type primary-qsig

isdn overlap receiving T302-3000

isdn incoming Voice Voice -

isdn T310 60000

isdn bchan-number-order ascending

isdn sending-complete

No keepalive

No fair-queue

No enable CDP

It is possible, hedge someone tell me?

2 REPLIES 2
Highlighted
Frequent Contributor

Re: Send the number and name on Caller ID via ISDN Qsig

Highlighted
VIP Mentor

Re: Send the number and name on Caller ID via ISDN Qsig

Yes,

It is possible. These are the features supported with QSIG.

Features Supported

CLIP-Calling Line (Number) Identification Presentation

CLIR-Calling Line (Number) Identification Restriction

© 2006 Cisco Systems, Inc. All right reserved.

Important notices, privacy statements, and trademarks of Cisco Systems, Inc. can be found on cisco.com

Page 4 of 100

CNIP-Calling Name Identification Presentation

CNIR-Calling Name Identification Restriction

COLP-Connected Line (Number) Identification Presentation

COLR- Connected Line (Number) Identification Restriction

CONP-Connected Name Identification Presentation

CONR- Connected Name Identification Restriction

Sending Alerting Name

CT-Call Transfer (by join)

CFU-Call Forwarding Unconditional (by join)

CFB-Call Forwarding Busy (by join)

CFNR-Call Forwarding No Reply (by join)

CFU-Call Forwarding Unconditional (by Reroute) - see Limitations Section

CFB-Call Forwarding Busy (by Reroute) - see Limitations Section

CFNR-Call Forwarding No Reply (by Reroute) - see Limitations Section

CCBS-Call Completion to Busy Subscriber - see Limitations Section

CCNR-Call Completion No Reply - see Limitations Section

ANF-PR-Additional Network Feature Path Replacement (for Call Transfer by join)

ANF-PR-Additional Network Feature Path Replacement (for Call Diversion by forward switching) - see Limitations Section

ANF-PR-Additional Network Feature Path Replacement (for Trombone connection)

MWI- Message Waiting Indication (lamp ON, lamp OFF)

Have alook at this document ans ee configuration for the callmanager side for QSIG.

Please rate all useful posts
CreatePlease to create content