03-29-2012 02:38 PM - edited 03-16-2019 10:22 AM
Hi,
I have a centralized IPT setup with CUCM 8.5 & voice gateway running on H.323 mode.
I have 2 requirements:
1. I have 4 analog lines terminated onto 4 FXO ports. I need any calls coming to that analog line should ring the reception extn 301345, where 301 is that branch code & 345 is the extn no. The reception phone is configured with 301345, however anyone within that branch will only dial 345, branch to branch calls will go via using a branch code. Kindly suggest how can i achieve this.
2. All normal users will make landline calls via local FXO line, rest other calls like mobile, international via PRI. Where as all managers will dial local as well as mobile, international always via PRI. Kindly suggest how can i achieve this.
03-29-2012 02:59 PM
1. TP to match 345 and prefix 301 which is only accesible to users on that branch (simply put, CSS/partitions)
2. Again, CSS and partitions. Adjust them so there's a RP for general users and another one for managers. Add a prefix for the calls from managers and then on GW create a dial-peer which will match calls with that prefix (and discard it) which points to the PRI. Regular dial-peer point to FXO.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
03-29-2012 03:03 PM
Hi Java,
Thanks for your prompt answer. I am not very much flexible with H323 model. Can you take one sample example & explain?
Rgds,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide