cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
625
Views
0
Helpful
1
Replies

Service Session command on dial-peer

a.vandalay
Beginner
Beginner

Hello,

I was wondering what does the "service session" command under dial-peer voice do?

I cannot find any info on any reference guides.

Thank you!

1 Reply 1

jamestomassoni
Beginner
Beginner

I was having an issue with an inbound dial peer where no matter what the outbound dial peer was it was delivering the the SIP invite with the wrong information in the "to" portion. It was delivering the to portion with the ip address of the out side / receiving interface instead of the ip of the outbound peer destination.  For example it was 5555551234@63.0.0.1 instead of 5555551234@10.1.1.1. When I removed the service session command from the dial peer it started working correctly.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: