Hi.
I wonder if it is possible to show the full cell phone number of the Remote Destination instead
of the associated DN.
If I set "Matching Caller ID with Remote Destination" to "Complete Match",
incoming calls from Remote Destinations show the full cell phone number, but the associated
line on the deskphone does not show up as "in use".
On the other hand, if I set "Matching Caller ID with Remote Destination" to "Partial Match" with "Number of Digits for Caller ID Partial Match" = 10,
an incoming call from a Remote Destination will show up with its associated DN instead of the full external number, but the associated Line
on the Deskphone will show a red light ("in use") like it should.
Is it possible to have both?
Showing the full external number of the RD AND showing the associated Line as "in use" on incoming calls?
Thanks in advance.
BTW: We use Callmanager 9.1.1
