12-09-2019 09:19 PM - edited 12-09-2019 09:20 PM
Hi,
When I do a “SHOW SIP-UA REGISTER STATUS”, I got two records: one is showing ".*" which registered status shows no; another one is the actual SIP number which registered status shows yes. Please see attached screenshot.
I got a problem of incoming calls can't hit the correct VOIP dial-peer, it keeps hitting a POTS dial-peer instead. I think this ".*" might be the problem. Any idea how can I get rid of it?
Regards
12-09-2019 09:48 PM
12-12-2019 09:49 PM
Hi Rajan,
Please see attached debug.
As you can see, it seems that the incoming call from 0215695635 hits POTS dial peer 10 for outgoing dial peer:
dial-peer voice 10 pots
tone ringback alert-no-PI
translation-profile outgoing OUT
destination-pattern .T
progress_ind alert enable 8
progress_ind progress enable 8
progress_ind connect enable 8
port 0/0/0:15
instead of VOIP dial peer 12 which it supposes to be as below.
dial-peer voice 12 voip
destination-pattern 95488147
session target ipv4:180.16.152.2
voice-class codec 1
The topology is like below:
ITSP ---(SIP)---- CUBE----(SIP)----CallManager---------- Cisco IP Phone
Can you please shrine some lights on?
Thank you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide