cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1084
Views
0
Helpful
1
Replies

Single CUBE - multiple ITSPs

Ruterford
Level 1
Level 1

Hi Everyone,

I am wondering if single CUBE router can be used to terminate multiple ITSP SIP trunks.

I will be using multiple authentications under  sip-ua.

 

Thanks

 

1 Accepted Solution

Accepted Solutions

Terry Cheema
VIP Alumni
VIP Alumni

You should be able to do that. Refer to below:

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/sip/configuration/15-mt/sip-config-15-mt-book/voi-sip-multi-trunks.html

Configuring Multiple Registrars on SIP Trunks


The Support for Multiple Registrars on SIP Trunks on a Cisco Unified Border Element, on Cisco IOS SIP TDM Gateways, and on Cisco Unified Communications Manager Express feature allows configuration of multiple registrars on Session Initiation Protocol (SIP) trunks, each simultaneously registered using their respective authentication instance. This feature allows a redundant registrar for each of the SIP trunks, which provides SIP trunk redundancy across multiple service providers.

There is a configuration example as well, look into it and see if it resolves your query.

-Terry

Please rate all helpful posts

View solution in original post

1 Reply 1

Terry Cheema
VIP Alumni
VIP Alumni

You should be able to do that. Refer to below:

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/sip/configuration/15-mt/sip-config-15-mt-book/voi-sip-multi-trunks.html

Configuring Multiple Registrars on SIP Trunks


The Support for Multiple Registrars on SIP Trunks on a Cisco Unified Border Element, on Cisco IOS SIP TDM Gateways, and on Cisco Unified Communications Manager Express feature allows configuration of multiple registrars on Session Initiation Protocol (SIP) trunks, each simultaneously registered using their respective authentication instance. This feature allows a redundant registrar for each of the SIP trunks, which provides SIP trunk redundancy across multiple service providers.

There is a configuration example as well, look into it and see if it resolves your query.

-Terry

Please rate all helpful posts