03-20-2014 09:48 PM - edited 03-16-2019 10:12 PM
Hi,
I just recently setup SIP connection to TIPT via my Cisco CUBE.
Call flow:
IP Phone -> SCCP -> CUCM -> SIP Trunk -> CUBE -> SIP TIPT
When a mobile calls into SIP DID, IP Phone x101 needs to transfer the call out to SIP again to another mobile phone, I get fast busy as soon as I hit the 1st digit of the called number.
CUCM is setup with the phone using the Device Pool that is programmed with MRGL. MRGL is then registered to the CUBE DSP for hardware conferencing.
Sorry, I'm new to SIP and I need assistant.
Thanks
03-25-2014 04:14 AM
could you please collect debug ccsip message & debug voice ccapi inout for a test call along with ccm traces? please post your cube config too.
03-25-2014 05:06 PM
Hi Suresh,
I will be on site to do thorough testing. I will post the debugs and reply to you.
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide