hello all my Cisco peps
We have a client with 4 pots lines from the carrier.
The carrier is moving to sip and the client does not want to buy a new phone system.
They have 4 inbound pots lines from the carrier.
I have set up a 2801 voice router and have 4 fxs ports.
I have the sip trunk up for inbound calls.
I cannot place outbound calls from the POTS FXS port.
I will be using the 2801 to do sip to pots lines hand off into the phone system.
Could someone help me with outbound calling on the fxs to the sip provider?
Take the analog out for a minute.
1. Can you place SIP calls to your ITSP?
2. Have you run a DNA to make sure the call is getting out of UCM and to your CUBEs or router?
This is a sip to POTS hand off. I am not able to make out bound call to the trunk provider. I can make inbound calls.
here is my dial peer config
dial-peer voice 100 pots description INBOUND TO ANALONG PORT 0 destination-pattern . port 0/1/0 forward-digits 0!dial-peer voice 1 voip description **CCA*North American*10-Digit Local** destination-pattern .......... progress_ind setup enable 3 session protocol sipv2 session target ipv4:184.108.40.206 voice-class codec 1 dtmf-relay rtp-nte clid network-number xxx-xxx-xxxx no vad
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: