09-19-2013 10:52 AM - edited 03-16-2019 07:27 PM
Dear all,
I have the following scenario:
CME#1 - SIP Trunk to provider
It's working perfect for my external calls.
From now on, I'll need to add a new CME#2 by a Sip Trunk to the one already in production, like this:
CME#2 ----- Sip Trunk ------ CME#1 -------- SIP Trunk to provider
Users registered on CME#1 can make external calls through provider with no problem.
Users on CME#2 doesn't.
The dial-peer on CME#2 has the same destination-pattern used on CME#1 - the only difference is that there's no translation rule on CME#2 - it's all made on CME#1.
Someone have an idea on what can I do to gather more information on it?
Regards,
Leandro
09-19-2013 11:15 AM
Hi Leandro.
Please attach here a show run and a debug ccsip messages during a call.
Thanks
Carlo
Sent from Cisco Technical Support iPhone App
09-20-2013 02:44 PM
Hi,
On CME1
do you have allow conn sip-to-sip under voice service voip ?
Also if you could provide what Carlo asked will be good
Regards
Haitham
09-20-2013 09:09 PM
Please share full "sh run" and "sh version" from both CMEs, along with debugs for an affected call:
deb voice ccapi inout
deb ccsip messages
You may want to use the information on the following link to collect the debugs correctly:
https://supportforums.cisco.com/docs/DOC-16310
--
Jorge Armijo
Please remember to rate helpful responses and identify helpful or correct answers.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide