09-19-2013 10:52 AM - edited 03-16-2019 07:27 PM
Dear all,
I have the following scenario:
CME#1 - SIP Trunk to provider
It's working perfect for my external calls.
From now on, I'll need to add a new CME#2 by a Sip Trunk to the one already in production, like this:
CME#2 ----- Sip Trunk ------ CME#1 -------- SIP Trunk to provider
Users registered on CME#1 can make external calls through provider with no problem.
Users on CME#2 doesn't.
The dial-peer on CME#2 has the same destination-pattern used on CME#1 - the only difference is that there's no translation rule on CME#2 - it's all made on CME#1.
Someone have an idea on what can I do to gather more information on it?
Regards,
Leandro
09-19-2013 11:15 AM
Hi Leandro.
Please attach here a show run and a debug ccsip messages during a call.
Thanks
Carlo
Sent from Cisco Technical Support iPhone App
09-20-2013 02:44 PM
Hi,
On CME1
do you have allow conn sip-to-sip under voice service voip ?
Also if you could provide what Carlo asked will be good
Regards
Haitham
09-20-2013 09:09 PM
Please share full "sh run" and "sh version" from both CMEs, along with debugs for an affected call:
deb voice ccapi inout
deb ccsip messages
You may want to use the information on the following link to collect the debugs correctly:
https://supportforums.cisco.com/docs/DOC-16310
--
Jorge Armijo
Please remember to rate helpful responses and identify helpful or correct answers.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: