03-06-2012 12:07 AM - edited 03-16-2019 09:57 AM
Dear all,
Good Monring....
Is it possible to SPA 500 AND SPA 300 SERIES IP PHONES to CUCM......?
or these phone made for only CCM Busuiness Edition Only....?
Goooood Day...
Regards,
Midhun Kunnukattil Madhu
Solved! Go to Solution.
03-06-2012 12:13 AM
Hi
Natively SPA500 and 300 are not supported in CUCM.
These phones supports standard SIP and SPCP (Tokenized Skinny), not SCCP.
So you can add them as third party SIP phone in CUCM.
But note these are still not tested to work with Cisco CUCM.
Regards
Ronak patel
03-06-2012 12:19 AM
Please rate post if it was helpful....
Cheers
Ronak patel
03-06-2012 12:13 AM
Hi
Natively SPA500 and 300 are not supported in CUCM.
These phones supports standard SIP and SPCP (Tokenized Skinny), not SCCP.
So you can add them as third party SIP phone in CUCM.
But note these are still not tested to work with Cisco CUCM.
Regards
Ronak patel
03-06-2012 12:15 AM
Hi Ronak,
Is there any .cop.sgn device enabler available for these phone to directly adding to CUICM....???
Regards,
Midhun KM
03-06-2012 12:16 AM
Unfortunately no, You can not add these phone natively to cisco CUCM.
03-06-2012 12:18 AM
Thanks...... RP....!!!!!!!!!!
03-06-2012 12:19 AM
Please rate post if it was helpful....
Cheers
Ronak patel
10-11-2012 11:50 PM
hi Team,
Help me to check if this SAP 301 model can add to CUCM version 4.2 as third party SIP phone?
Appreciate the Reply ASAP.
Regards,
May
10-12-2012 12:14 AM
Hi
These phones are not tested to work with CUCM 4. But you may follow normal procedure to add third party phone and see if it works.
I do not have CUCM 4.2 to test it.
Regards
Ronak Patel
Rate helpful posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide