I'm trying to configure an SPA3102 with as asterisk box.
I'm having an issue with the disconnect tone detection.
Right now I can have two configurations, one:
* If I receive a call on the PSTN and the caller disconnects before I answer the SPA3102 doesn't detect the disconnection and phones continue ringing. This configuration has a PSTN Ring Timeout very high (600).
another: * If I receive a call the phone rings for 5 seconds, stops, rings agains a couple seconds, stops, rings again, and continues like this until the caller disconnects. This configuration has a PSTN Ring Timeout with a default value (5).
I tried changing the Disconnect Tone with a lot of values I got from many places (including the values from www.3amsystems.com). I also tried with different FXO Port Impedance values.
I can't understand either why SAP3102 with an high PSTN Ring Timeout doesn't disconnect the call, and why it does a loop with ringing on the phone with the PSTN Ring Timeout set to low.
Hello guys,As I have read the Facebook messenger could integrate with UCCX to handle chat as webchat support,. there is a webhook on Facebook that instructed us to write the CCP URL with HTTPS as a Callback URL after writing the tokens from UCCX to FB and...
You can use the CLI command 'show risdb query sip' to check the status of SIP Trunks on Cisco Unified Communications Manager (Unified CM, CUCM).
admin:show risdb query sip
----------- SIP Information -----------
Number of SIP entries: 1
I am currently working on separating our Contact Center users from our Corporate Users via LDAP Custom Filters so that we can apply specific Feature Group Template to our Contact Center users and a specific template to our Corporate users. I did not...