09-19-2011 12:33 PM - edited 03-16-2019 07:04 AM
Is there any way to configure the SPA501g on CME 7 ?
Tks
03-08-2012 12:06 PM
Hello...
You can try with this commands
voice service voip
ip address trusted list
ipv4 172.30.0.0 255.255.254.0
allow-connections sip to sip
fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none
sip
registrar server expires max 600 min 60
!
voice class codec 1
codec preference 1 g711ulaw
codec preference 2 g729r8
!
!
voice register global
mode cme
source-address 172.30.0.1 port 5060
timeouts interdigit 2
max-dn 70
max-pool 70
authenticate register
authenticate realm csb.com
tftp-path flash:
file text
create profile sync 0006058169035549
!
voice register dn 1
number 505050
!
voice register pool 1
id mac 7081.053E.227C
number 1 dn 1
template 1
dtmf-relay sip-notify
username user1 password cisco
codec g711ulaw
I configure this phone with CME 9.0 but i think it could work with 7.0 too
I hope it helps
03-08-2012 01:21 PM
SPA phones in SCCP (SCPC actually) mode are supported on the UC5x0 only.
If you can convert them to SIP you can configure as third-party, but they will work poorly and without features.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: