04-25-2011 12:42 PM - edited 03-16-2019 04:39 AM
Has anyone connected a SPA8000 with CUCM? I'm a little confused as to how you would setup the numbers, and what to do about only having one MAC address.
If anyone has any details about how to get these two to work together would be great (the more detailed the better)
Thanks,
04-26-2011 11:16 AM
Alright, I was able to get line 1 connected, but I'm not sure how I could get the other 7.
To get the 1st line, I created and End User with the sip user/pass
Then I created a 3rd party sip phone and used the MAC address of the SPA8000
Finally I added my DN that I wanted assoicated with that line to the phone.
This works, but the problem is I only have 1 line connected, and I'm out of MAC addresses to use for any of the additional lines.
Suggestions?
04-26-2011 12:17 PM
Alright, I was able to get line 1 connected, but I'm not sure how I could get the other 7.
To get the 1st line, I created and End User with the sip user/pass
Then I created a 3rd party sip phone and used the MAC address of the SPA8000
Finally I added my DN that I wanted assoicated with that line to the phone.
This works, but the problem is I only have 1 line connected, and I'm out of MAC addresses to use for any of the additional lines.
Suggestions?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide