im going to shift a cucm from cme and i need to shift call recording from cme to the new cucm as well , im using span ports for a call recording server to record calls at a customer , however i cant understand how the design is functioning , a CME is having another switch as the span source which doesnt make sense as the CME is the telephony system , how ever on the switch i cant understand the span command , can someone explain for me what does "encapsulation replicate ingress dot1q vlan 200" means? also does all the voice traffic and speech goes through the cme ports?
I am writing this blog for work around for the following error while pulling the CDR resports "10021 there are no matching records".
Please follow the below work around:
Please verify the CDR configuration on System->S...
I tried to upgrade the firmware of my Cisco 7960 into SIP using a CISCO 2811 router and a CISCO 2960 switch. The upgrade is successful, but the IP phones keep on showing UNPROVISIONED SIP. How could I fix this. I'm trying to build an IP telephony sys...
I have a customer that is running CME 12 and all of his phones located at the office where the CME resides work just fine. We just connected a satellite office to it using a ASA to ASA Site to Site VPN Tunnel. The remote site is work...